The first thing I look at on one of these machines is the paint around the die blocks, because a faint, shiny wear mark in the coating shows where hands and tools have been working and how the metal underneath has coped. A multi-station cold heading forming machine is built largely from heavy castings, hardened steel tooling, bearings, and a few softer parts such as seals and hoses, and each of those materials ages in its own way.

The frame carries everything else. A thick, well-ribbed casting or fabricated body keeps the slide and the dies in line while the machine hammers away for hours, and a frame that flexes even slightly lets the punch wander off the die center. I have no specification sheet for any particular model in front of me, so I am describing the general picture. Rap a knuckle on a side panel and a dense, short thud is a good sign, whereas a ringing, thin sound suggests less mass behind the surface.

Tooling takes the hardest punishment. Dies, punches, and cutters are made from hardened steel because they meet wire again and again under heavy pressure, yet hardened steel can chip if it is too brittle or wear quickly if it is too soft. Look at the working faces under a torch and you should see a smooth, even polish, while scoring lines, tiny pits, or a rim of flaking metal point to trouble. I once picked up a worn punch from a bin and ran a thumbnail across its nose, and the nail caught on a ridge that explained why the heads on the finished parts had been coming out lopsided.

Feed parts deserve the same attention. Rollers, grippers, and the cutting quill handle wire that arrives dusty, oily, and sometimes slightly rough, so their surfaces glaze or groove over time. Turn a roller by hand and it should rotate with a smooth whisper, since a gritty rumble means a bearing is already tired, and a groove worn into the surface will let wire slip and shift.

Lubrication and heat are the quiet drivers of life. Oil carries away heat and metal fines, so pipes, filters, and pumps matter as much as any steel part, and a machine whose oil looks dark, gritty, or cloudy is telling you something. Check that lines are routed away from hot spots and that fittings are dry, because a weeping joint is both a mess and a hint about how carefully the machine was assembled.

Seals, hoses, and guards are the soft materials that go first. Rubber stiffens with heat, plastic guards crack at their fixings, and fasteners that cannot be removed without stripping tend to leave a machine uncleaned. Open a guard and look at the unpainted corners instead of trusting a fresh coat of color, since dust and oil paste collect where nobody wipes.

Electrical parts and wiring count as materials too, even when they hide behind a door. Cables should be neatly routed with clear labels and sleeves where they bend, connectors should click in firmly, and the cabinet should feel clean and dry inside. Ask the supplier in writing which components are fitted and where spares come from, since the working life of the whole machine often depends on one small part being available when it is needed.

Photographs on https://www.lhmachinery.com can show layouts and stations, yet the thickness of a casting wall and the polish on a die face only appear when you put a hand and a light on them. In front of me now the multi-station cold heading forming machine stands with its guard open, and I am running a thumb along the edge of a die block, feeling for any chip while a thin line of oil creeps down the steel.